Notebook

Notebook, 1993-

MATERIALS & METHODS - Painting - Oil Painting

Characteristics - Painting Methods & Techniques - Materials and Equipment - Work Space & Storage - Manufacture of Pigments - Protection of the Picture

Oil Painting
Adhesion or Anchorage of Coatings


Paint [and, for that matter, gesso, oil grounds, plaster, and any other coating as well] must adhere permanently to the surfaces to which it is applied; flaking, peeling, blistering, and similar defects are most frequently caused by simple lack of adhesion. Aside from the adhesive or gluelike action of the coating itself, permanent adherence depends largely on the nature of the surface to which it is applied. There are two kinds of surfaces which are satisfactory for promoting and assisting permanent adherence on coatings.

1. An absorbent or porous surface which will partially imbibe the paint vehicle.

2. A rough, textural surface [granular, fibrous, weblike, or scored] which will hold the dried paint in a mechanical grip or bond.

A slick, shiny, completely nonabsorbent surface is the least likely to offer permanent adhesion. A coating that is too absorbent is generally not desirable; for example, an unsized gesso coating with full absorbency may take watercolor and tempera very well, but it will absorb so much of an oil vehicle as to leave the paint in a weak condition, a development more likely with heavy, thick coatings than with thin or very thin coats. Extreme absorbency can be reduced by the use of a size, as previously mentioned.

As a general rule, a combination of the proper degree of tooth plus the proper degree of absorbency is desirable. However, for some painting methods that coarseness of texture of a nonabsorbent ground or the absorbency of a smooth ground will alone suffice to promote good adhesion of the surface coating to the support.

A common cause of poor adhesion and of the development of various defects through weakening of the paint film is the use of stale oil colors--blobs of color that have been too long exposed to air on the palette, where they have begun to go through their drying action and have thickened. Painters who "freshen" such colors by adding turpentine to them delude themselves; the thickened oils have already gone though their sticky, adhesive stage [p. 103] either partially or wholly while on the palette, and they have little or no chance of equaling the adhesive power or film strength of fresh colors. [pp. 103-104]

[Mayer, Ralph. The Painter's Craft. An Introduction to Artist's Methods and Materials. Revised and updated by Steven Sheehan, Director of the Ralph Mayer Center, Yale University School of Art. New York: Penquin Group. 1948. 1991.]




NOTEBOOK | Links

Copyright

The contents of this site, including all images and text, are for personal, educational, non-commercial use only. The contents of this site may not be reproduced in any form without proper reference to Text, Author, Publisher, and Date of Publication [and page #s when suitable].